|
AT commands: Detailed description
43
|
devolo MicroLink ISDN i
|
EN
The S93 value is overwritten after every AT unless the automatic bit rate
identification is switched off in register S51.
S95 Bit-oriented option
The contents of register S95 is stored in the nonvolatile memory with the
commands AT&W or AT*W. The individual bits have the following signifi
-
cance:
S96 Bit-oriented option
The contents of register S96 is stored in the nonvolatile memory with the
command AT*W. The individual bits have the following significance:
Bit Dec. Description Command
0..3 0 0 CONNECT messages not modified AT\V0
1 1 Identification of error-free connections AT\V1
2 2 Differentiation of MNP – V.42 AT\V2
8 8 Detailed acknowledgment AT\V8
4 0 0 CONNECT messages dependent on
AT\V
AT-M0
16 1 CONNECT messages independent of AT\V AT-M1
5 0 0 CONNECT message after invalid
escape sequence
AT*Q0
32 1 No CONNECT message after invalid
escape sequence
AT*Q1
6..7 0 0 Messages on ATQ0
64 1 Messages off ATQ
128 2 Messages off in answer mode ATQ2
Bit Dec. Description
0..1 0 0 Decimal display of S registers
1 1 Hexadecimal display of S registers
2 2 Binary display of S registers
2 0 0 Message 'Continue with any character...' yes
4 1 Message 'Continue with any character...' no
To Next Page
Loading...
