Need help?Do you have a question about the DeWalt 28-160 and is the answer not in the manual?
Process for attaching the band saw table to the frame.
Attaching the pointer mechanism to the saw frame using a screw.
Installing the table insert and its alignment components onto the table.
Guidelines for electrical circuit requirements and extension cord usage for the band saw.
Critical safety procedures for grounding the tool to prevent electric shock.
Steps to properly set and check the tension of the saw blade.
Procedure for aligning the saw blade to run centered on the wheels.
Setting the height of the upper blade guide assembly relative to the workpiece.
Aligning the upper blade guides close to the saw blade without pinching.
Positioning the upper blade support bearing to prevent blade push-back.
Adjusting lower blade guides and bracket for different blade widths and support.
Location and operation of the band saw's power switch.
To Next Page
General
