DeWalt D55152 - Page 22

22
English
CODE POSSIBLE CAUSE POSSIBLE SOLUTION
18
Detergent type oil being used in pump Drain oil and rell pump using
SAe 5W-40 full syntheticoil.
19
Motor overload protection switch has tripped
See Motor Overload underFeatures.
20
Extension cord is wrong length or gauge Check for proper gauge wire and cord length. See
Extension Cords underInstallation.
21
Loose electrical connections Contact a
DeWALT
factory service center or a
DeWALT
authorized servicecenter.
22
Possible defective motor or starting capacitor Contact a
DeWALT
factory service center or a
DeWALT
authorized servicecenter.
23
Paint spray on internal motor parts
Contact a
DeWALT
factory service center or a
DeWALT
authorized service center.
Do not operate the
compressor in the paint spray area. See flammable
vapor warning.
24
Fuse blown, circuit breaker tripped
1. Check fuse box for blown fuse and replace as necessary.
Reset circuit breaker. Do not use a fuse or circuit breaker
with higher rating than that specied for your particular
branchcircuit.
2. Check for proper fuse. Use only a time delayfuse.
3. Check for low voltage conditions and/or proper
extensioncord.
4. Disconnect the other electrical appliances from circuit or
operate the compressor on its own branchcircuit.
25
Tank pressure exceeds pressure switch cut-in pressure
Motor will start automatically when tank pressure drops
below cut-in pressure of pressureswitch.
26
Pressure release valve on pressure switch has not unloaded
head pressure
Set the On/Off switch to OFF. If the valve does not open,
replace switch. Contact a
DeWALT
factory service center or a
DeWALT
authorized servicecenter.