16
Important
To assure product SAFETY and RELIABILITY, repairs,
maintenance and adjustment should be performed by
Black & Decker (U.S.) Inc. industrial tool service centers or
other qualified service organizations. These service
organizations service D
EWALT tools always using
DEWALT replacement parts.
Full Warranty
DEWALT heavy duty Industrial tools are warranted for one
year from date of purchase. We will repair, without charge,
any defects due to faulty materials or workmanship.
Arrangements have been made with the Industrial Tool
Division of Black & Decker (U.S.) Inc. to provide warranty
repairs for D
EWALT tools. Please return the complete unit,
transportation prepaid, to any Black & Decker (U.S.) Inc.
industrial service center or authorized service station listed
under “Tools, Electric” in the yellow pages. This warranty
does not apply to accessories or damage caused where
repairs have been made or attempted by others. This
warranty gives you specific legal rights and you may have
other rights which vary from state to state.
In addition to the warranty, D
EWALT tools are covered by
our:
30 DAY NO RISK SATISFACTION GUARANTEE
If you are not completely satisfied with the performance of
your D
EWALT heavy duty Industrial tool, simply return it to
the participating seller within 30 days for a full refund.
Please return the complete unit, transportation prepaid.
Proof of purchase may be required.
Trouble Shooting Guide
BE SURE TO FOLLOW SAFETY RULES AND INSTRUCTIONS
TROUBLE! SAW WILL NOT START
WHAT’S WRONG? WHAT TO DO…
1. Saw not plugged in 1. Plug in saw.
2. Fuse blown or circuit breaker tripped 2. Replace fuse or reset circuit breaker
3. Cord damaged 3. Have cord replaced by authorized service center
4. Brushes worn out 4. Have brushes replaced by authorized service
center or replace them yourself as instructed on page 10.
TROUBLE! SAW MAKES UNSATISFACTORY CUTS
WHAT’S WRONG? WHAT TO DO…
1. Dull blade 1. Replace blade. See page 7.
2. Blade mounted backwards 2. Turn blade around. See page 7.
3. Gum or pitch on blade 3. Remove blade and clean with turpentine and
coarse steel wool or household oven cleaner.
4. Incorrect blade for work being done 4. Change the blade. See page 7.
TROUBLE! BLADE DOES NOT COME UP TO SPEED
WHAT’S WRONG? WHAT TO DO…
1. Extension cord too light or too long 1. Replace with adequate size cord. See page 4.
2. Low house current 2. Contact your electric company
TROUBLE! MACHINE VIBRATES EXCESSIVELY
WHAT’S WRONG? WHAT TO DO…
1. Saw not mounted securely to stand or work bench 1. Tighten all mounting hardware. See page 5.
2. Stand or bench on uneven floor 2. Reposition on flat level surface. See page 5.
3. Damaged saw blade 3. Replace blade. See page 7.
TROUBLE! DOES NOT MAKE ACCURATE MITER CUTS
WHAT’S WRONG? WHAT TO DO…
1. Miter scale not adjusted correctly 1. Check and adjust. See page 8.
2. Blade is not square to fence 2. Check and adjust. See page 8.
3. Blade is not perpendicular to table 3. Check and adjust fence. See page 8.
4. Workpiece moving 4. Clamp workpiece to fence or glue 120 grit
sandpaper to fence with rubber cement.
TROUBLE! MATERIAL PINCHES BLADE
WHAT’S WRONG? WHAT TO DO…
1. Cutting bowed material 1. Position bowed material as shown on page 14.
See ‘Tools-Electric’
–Yellow Pages–
for Service & Sales
To Previous Page
Loading...
