DeWalt DW714 - Page 55

ENGLISH
53
17
50
51
Fig. S
Adjusting the Fence (Fig. T)
The upper part of the fence can be adjusted to provide
clearance, allowing the saw to bevel to 45° left and 0° right.
To adjust the left fence
22
:
1. Loosen the left side fence clamping knob
11
and slide
the fence to the left.
2. Make a dry run with the saw switched off and check for
clearance. Adjust the fence to be as close to the blade
as practical to provide maximum workpiece support,
without interfering with the up and down movement
of the arm.
3. Tighten the knob securely.

WARNING: The guide grooves
52
can become
clogged with sawdust. Use a stick or some low
pressure air to clear the guide grooves.
Fig. T
11
52
22
Checking and Adjusting the Bevel Angle
(Fig. T, U)
1. Loosen the left side fence clamping knob
11
and slide
the upper part of the left side fence to the left as far as
it will go.
2. Loosen the bevel clamp knob
16
and move the saw
arm to the left until the angle position stop
26
rests on
the bevel position adjustment stop
27
. This is the 45°
bevel position.
If adjustment is required, proceed as follows:
3. Loosen the locknut
49
a few turns and turn the bevel
position adjustment stop screw
27
in or out until the
pointer
50
indicates 45° with the angle position stop
26
resting on the bevel position adjustment stop.
4. Firmly tighten the lock nut
49
while holding the stop
screw
27
stationary.
5. To achieve a 0° right bevel or a 45° left bevel, the two
adjustment stop screws must be adjusted to allow the
saw arm to move asnecessary.
Fig. U
26
49
50
16
27
Adjusting the Depth Stop (Groove Cuts)
(Fig. V)
The depth stop adjustment screw
45
can be turned
clockwise to reach the desired depth of cut for grooves.
1. Tilt the saw head to the desired position for the
groovecut.
2. Turn the adjustment screw
45
clockwise until the end
of the screw touches the housingstop.
3. Guide the tool head slowly upward.
NOTE: AFTER THE GROOVE CUT IS COMPLETE RETURN
THE DEPTH STOP ADJUSTMENT SCREW TO THE
ORIGINAL POSITION.
NOTE: ENSURE THAT THE SAW BLADES DO NOT TOUCH
ANY PART OF THE BASE OR KERFPLATE.
45
Fig. V