DeWalt DW714 - Page 54

ENGLISH
52
Fig. M
46
9
Checking and Adjusting the Blade to
the Table (Fig. N–S)
1. Loosen the bevel clamp knob
16
.
Fig. N
16
2. Press the miter arm to the right to ensure it is fully
vertical with the angle position stop
26
located against
the vertical position adjustment stop
28
and tighten
the bevel clamp knob.
Fig. O
26
28
3. Pull down the head until the blade just enters the saw
kerf
19
.
4. Place a set square
46
on the table and up against the
blade
41
(Fig.P).

WARNING: Do not touch the tips of the blade teeth
with the square.
Fig. P
41
46
19
22
If adjustment is required, proceed as follows:
5. Loosen the lock nut
49
a few turns, and while making
sure the stop screw
28
is firmly in contact with the
angle position stop
26
, turn the vertical position
adjustment stop screw
28
in or out until the blade is at
90º to the table as measured with the square.
Fig. Q
26
28
49
6. Firmly tighten the lock nut
49
while holding the stop
screw
28
stationary.
Fig. R
49
28
26
7. If the bevel pointer
50
does not indicate zero on the
bevel scale
17
, loosen the screw
51
that secures the
pointer and move the pointer as necessary.