DeWalt DW872 - Fitting a Mains Plug to 115 V Units; Using an Extension Cable; Package Contents; Markings on Tool

8
ENGLISH
• Use correctly sharpened saw blades. Observe the maximum
speed marked on the saw blade;
• Ensure that any spacers and spindle rings used are suitable for
the purpose as stated by the manufacturer;
• Refrain from removing any cut-offs or other parts of the
workpiece from the cutting area while the machine is running
and the saw head is not in the rest position;
• Ensure that the machine is always stable and secure. (e.g. fixed
to a bench)
• To support long pieces see FigureC3.

WARNING: We recommend the use of a residual current
device with a residual current rating of 30mA orless.
Residual Risks
The following risks are inherent to the use of saws:
• Injuries caused by touching the rotating parts
• Injuries caused by disruption of the cuttingblade.
These risks are most evident:
• Withing the range of operation
• Within the range of the rotating machine parts
In spite of the application of the relevant safety regulations
and the implementation of safety devices, certain residual risks
cannot be avoided. These are:
• Impairment ofhearing.
• Risk of accidents caused by the uncovered parts of the rotating
sawblade.
• Risk of injury when changing theblade.
• Risk of squeezing fingers when opening theguards.
Electrical Safety
The electric motor has been designed for one voltage only.
Always check that the power supply corresponds to the voltage
on the ratingplate.
Your
DeWALT
tool is double insulated in accordance
with EN62841; therefore no earth wire isrequired.

WARNING: 115 V units have to be operated via a fail-safe
isolating transformer with an earth screen between the
primary and secondary winding.
If the supply cord is damaged, it must be replaced only by
DeWALT
or an authorised serviceorganisation.
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the oldplug.
• Connect the brown lead to the live terminal in theplug.
• Connect the blue lead to the neutralterminal.

WARNING: No connection is to be made to the
earthterminal.
Follow the fitting instructions supplied with good quality plugs.
Recommended fuse: 13A.
Fitting a Mains Plug to 115 V Units
(U.K. and Ireland Only)
• The plug fitted should be comply with BS EN 60309 (BS4343),
16 Amps, earthing contact position4h.

WARNING: Always ensure that the cable clamp is
correctly and securely fitted to the sheath of thecable.
Using an Extension Cable
If an extension cable is required, use an approved 3–core
extension cable suitable for the power input of this tool (see
Technical Data).The minimum conductor size is 1.5 mm
2
; the
maximum length is 30m.
When using a cable reel, always unwind the cablecompletely.
Package Contents
The package contains:
1 Multicutter
1 Cutting blade
1 Hex key
1 Vertical clamp
1 Instruction manual
• Check for damage to the tool, parts or accessories which may
have occurred duringtransport.
• Take the time to thoroughly read and understand this manual
prior tooperation.
Markings on Tool
The following pictograms are shown on the tool:
Read instruction manual beforeuse.
Wear earprotection.
Wear eyeprotection.
Date Code Position (Fig. A)
The date code
26
, which also includes the year of manufacture,
is printed into thehousing.
Example:
2019 XX XX
Year of Manufacture
Description (Fig. A)

WARNING: Never modify the power tool or any part of it.
Damage or personal injury couldresult.
1
On/off switch
2
Main handle
3
Carrying handle
4
Guard
5
Spindle lock
6
Material clamp
7
Fence