DeWalt DW872 - Transporting; Proper Hand Position; MAINTENANCE; Optional Accessories

11
ENGLISH
Transporting (Fig. F)
The tool is equipped with a lock-down pin
21
which locks the
tool in closed-down position forcarrying.
Lower the guard
4
onto the cutting table
9
and secure the
tool in this position by pushing in the lock-down pin
21
.
Transport the tool using the carrying handle
3
.
To release the tool, pull out the lock-down pin
21
.
Proper Hand Position (Fig. A, G)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position asshown.

WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
suddenreaction.
Proper hand position requires one hand on the main handle
2
and the other hand holding the workpiece away from theblade.

WARNING:
• Never place your hands near the cuttingarea.
• Hold the workpiece tightly to the table and the fence
when cutting. Keep your hands in position until
the switch has been released and the blade has
completelystopped.
• Do not cross yourhands.
• Keep both feet firmly on the floor and maintain
properbalance.
MAINTENANCE
Your
DeWALT
power tool has been designed to operate
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regularcleaning.

WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect tool from power
source before making any adjustments or removing/
installing attachments or accessories. An accidental
start-up can causeinjury. in the OFF position. An
accidental start-up can causeinjury.
Lubrication
Your power tool requires no additionallubrication.
Cleaning

WARNING: Blow dirt and dust out of the main housing
with dry air as often as dirt is seen collecting in and around
the air vents. Wear approved eye protection and approved
dust mask when performing thisprocedure.

WARNING: Never use solvents or other harsh chemicals
for cleaning the non-metallic parts of the tool. These
chemicals may weaken the materials used in these parts.
Use a cloth dampened only with water and mild soap.
Never let any liquid get inside the tool; never immerse any
part of the tool into aliquid.
Optional Accessories

WARNING: Since accessories, other than those offered
by
DeWALT
, have not been tested with this product, use
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only
DeWALT
recommended
accessories should be used with thisproduct.
Consult your dealer for further information on the
appropriateaccessories.
Protecting the Environment
Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
householdwaste.
Products and batteries contain materials that can
be recovered or recycled reducing the demand for raw
materials. Please recycle electrical products and batteries
according to local provisions. Further information is available at
www.2helpU.com.