12
MAINTENANCE
LUBRICATION
Perform maintenance below after each 20 hours of use.
1. DISCONNECT MACHINE FROM POWER SOURCE.
2. Remove the four screws (A) Fig. 26, and side panel
(B).
3. Release blade tension by moving blade tension lever
to the vertical position.
4. Remove the two pivot bolts and wave washers (C)
Fig. 27.
5. Fig. 28 illustrates one of the pivot bolts and wave
washers (C) removed. Thoroughly clean grease from
shafts of both pivot bolts and lubricate shafts with a few
drops of light machine oil.
6. Re-assemble the two pivot bolts and replace side
panel. Re-apply tension to the blade.
A
A
B
Fig. 26
C
Fig. 27
C
Fig. 28
To Next Page
Loading...
