DeWalt XR LI-ION DCN680 - Storage Recommendations; Battery Type

36
ENGLISH
batteries of 36 Wh each. The Use Wh rating might indicate
108Wh (1batteryimplied).
Storage Recommendations
1. The best storage place is one that is cool and dry away
from direct sunlight and excess heat or cold. For optimum
battery performance and life, store battery packs at room
temperature when not inuse.
2. For long storage, it is recommended to store a fully charged
battery pack in a cool, dry place out of the charger for
optimalresults.
NOTE: Battery packs should not be stored completely depleted
of charge. The battery pack will need to be recharged beforeuse.
Labels on Charger and Battery Pack
In addition to the pictographs used in this manual, the labels
on the charger and the battery pack may show the following
pictographs:
Read instruction manual beforeuse.
See Technical Data for chargingtime.
Do not probe with conductiveobjects.
Do not charge damaged batterypacks.
Do not expose to water.
Have defective cords replacedimmediately.
Charge only between 4 ˚C and 40 ˚C.
Only for indooruse.
Discard the battery pack with due care for
theenvironment.
Charge
DeWALT
battery packs only with designated
DeWALT
chargers. Charging battery packs other than
the designated
DeWALT
batteries with a
DeWALT
charger may make them burst or lead to other
dangeroussituations.
Do not incinerate the batterypack.
USE (without transport cap). Example: Wh rating
indicates 108 Wh (1 battery with 108 Wh).
TRANSPORT (with built-in transport cap). Example:
Wh rating indicates 3 x 36 Wh (3batteries of 36Wh).
Battery Type
The DCN680 operates on an 18 volt batterypack.
DCB127, DCB181, DCB182, DCB183, DCB183B, DCB184,
DCB184B, DCB185, DCB187, DCB189, DCB546, DCB547, DCB548.
Refer to Technical Data for moreinformation.
Package Contents
The package contains:
1 Nailer
3 Non-mar tips
1 Charger
1 Li-Ion battery pack (C1, D1, L1, M1, P1, S1, T1, X1, Y1 models)
2 Li-Ion battery packs (C2, D2, L2, M2, P2, S2, T2, X2, Y2 models)
3 Li-Ion battery packs (C3, D3, L3, M3, P3, S3, T3, X3, Y3 models)
1 Instruction manual
• Check for damage to the tool, parts or accessories which may
have occurred duringtransport.
• Take the time to thoroughly read and understand this manual
prior tooperation.
NOTE: N and NT versions are not supplied with batteries or
acharger.
Markings on Tool
The following pictograms are shown on the tool:
Read instruction manual beforeuse.
Wear earprotection.
Wear eyeprotection.
Do not operate tool on scaffoldings,ladders.
Length ofnails.
Nailgauge.
Magazinecapacity.
Toolvoltage.
Magazine angle: 0˚.
Date Code Position (Fig. B)
The date code
18
, which also includes the year of manufacture,
is printed on the tool foot between the face of the battery and
thenailer.
Example:
2020 XX XX
Year of Manufacture