Dexter Laundry C-Series Original Instructions

8514-219-001 REV E PAGE 19
TEMPORARY DRYER CONTROLLER PROGRAMMING
The temporary programming mode will allow the change of the stored dry cycle settings in
the dryer controller for one complete dry cycle. After the dry cycle is complete, the default
settings that existed before the temporary change are restored. The temporary dry cycle can
be stopped and cleared at any time during the dry cycle operation.
To temporarily change a dryer controller cycle, follow the procedures below. Things that
are displayed on the 4-digit numeric display will be in “quotation marks”. Touch pad switches
on the dryer controller that physically need to be pressed will be in CAPITAL AND BOLD
LETTERS.
If, at any time, you want to escape the temporary programming mode while changing the
program settings, you can press the STOP touch pad switch on the dryer controller if the 4-
digit numeric display is not flashing. The SELECT/ENTER touch pad switch on the dryer
controller can be pressed and released to enter the flashing value shown on the 4-digit
numeric display and allow you to escape.
If you press and release the STOP touch pad switch on the dryer controller, when the 4-
digit numeric display is not flashing, the temporary changes to the dry cycle program will be
cancelled. The stored dry cycle settings that existed before the temporary change will then be
restored.
If, at any time, you want to start the temporary dry cycle during the temporary
programming mode, press and release the START touch pad switch on the dryer controller if
the 4-digit numeric display is not flashing. The SELECT/ENTER touch pad switch on the dryer
controller can be pressed and released to enter the flashing value shown on the 4-digit
numeric display and allow you to start the temporary dry cycle. If you start the temporary dry
cycle, the 4-digit numerical display will change to the total dry time and count down to 0 as
the dry cycle progresses.
__________________________________________________________________
PROCEDURE
1) Make sure the dryer is not in a dry cycle. The 4-digit numeric display on the dryer
controller will show “LOAd” when the dryer is not in a dry cycle.
2) Press and release the UP or DOWN touch pad switch on the dryer controller to chose the
dry cycle that you want to change (dry cycle 1 through 5). The dry cycle L.E.D. will
illuminate to indicate which dry cycle you are choosing. If you press either the UP or
DOWN touch pad switch and hold it down, the controller will sequence through the five
dry cycles.
3) Press and release the CYCLE touch pad switch on the dryer controller once you have
chosen the dry cycle you want to change. After you press the CYCLE touch pad switch,
the programming L.E.D. and the dry time L.E.D. will illuminate, the dry cycle L.E.D. will
remain illuminated, and the total dry time will be displayed on the 4-digit numeric display.
4) Press and release the UP or DOWN touch pad switch on the dryer controller to change the
total cycle time. Once either of the UP or DOWN touch pad switch is pressed, the dry

Dexter Laundry C-Series Specifications

General

Brand	Dexter Laundry
Model	C-Series
Category	Dryer
Language	English