20
8514-311-001 REV PR
7 Instructions
Post the following “For Your Safety” caution in a prominent location:
WARNING
FOR YOUR SAFETY
THIS MACHINE IS FOR DRYING ONL
FABRICS CLEANED IN WATER
To avoid possibility of fire, including
spontaneous combustion, do not dry oiled
floor mops, items containing foam rubber or
similarly textured rubberlike materials or any
material on which you have used a cleaning
solvent, or which contains flammable liquids
or solids (such as petrol, kerosene, waxes,
etc.)
Fabric softeners, or similar products,
should be used per the fabric softener
instructions. Remove all objects from pockets
such as lighters and matches.
7.1 Dryer Installation
INFORMATION
All dryers must be installed in accordance
with all local, state and national building,
electrical, and other codes in effect in the
area. Electrical safety of these dryers has
been evaluated to the requirements of
European standard EN 60204-1.
7.1.1 Uncrating and Placing Dryer
Tools Required: 19 mm (¾ inch) hex socket & ratchet driver, wood block 100 mm (4 inches) or 125
mm (5 inches) thick, a knife and a groove joint pliers, which will open to 35 mm (1 3/8 inches).
1. Remove and discard packaging.
2. The crate base is attached to the dryer by 4 cap screws driven upward from below the crate
base. Remove crate base from dryer, by tipping dryer sidewise and place block under
crate base rail in center of dryer. Using a ratchet and 19 mm (¾ inch) hex socket,
remove and discard 2 crating bolts from side, which is raised. Remove block from under
crate base. Repeat for other side. Save the bolts for use if the dryer is ever moved
again.
WARNING
FOR YOUR SAFETY
DO NOT STORE OR USE GASOLINE OR
OTHER FLAMMABLE VAPORS OR LIQUIDS
IN THE VICINITY OF THIS OR ANY OTHER
APPLIANCE.
WARNING
INSTALLATION AND SERVICING
INSTRUCTIONS ARE FOR USE BY
QUALIFIED PERSONNEL ONLY. TO AVOID
INJURY AND ELECTRICAL SHOCK DO
NOT PERFORM ANY SERVICING OTHER
THAN THAT CONTAINED IN THE
OPERATING INSTRUCTIONS, UNLESS
QUALIFIED.
To Next Page
Loading...
Need help?
General
