46
8514-311-001 REV PR
7.3.1
Daily
1. Clean the lint screen. Use a soft brush if necessary.
2. Check the lint screen for tears. Replace if necessary.
3. Clean lint from the lint screen compartment.
7.3.2 Monthly
1. Remove lint accumulation from the end bells of the motors.
2. Remove lint accumulation from front control area.
3. Remove lint and dirt accumulation from the top of the dryer and all areas above, below,
and around the burners and burner housing. Failure to keep this portion of the dryer clean
can lead to a build-up of lint creating a fire hazard.
7.3.3 Quarterly
1. Check the belts for looseness, wear, or fraying.
2. Inspect the gasket of the door glass for excessive wear.
3. Check tightness of all fasteners holding parts to support channel.
4. Check tightness of all set screws.
5. Inspect the impeller for tightness of the blades to hub.
6. Remove the air flow switch assembly and check the tumbler thru-bolts for tightness.
7. Grease the pivot pins and the tension arms where in contact with each other. (Where
applicable)
7.3.4 Semi-Annually
1. Remove and clean the main burners.
2. Remove all orifices and examine for dirt and hole obstruction.
3. Remove all lint accumulation. Remove the front panel and the lint screen housing and
remove lint accumulation.
4. Apply a few drops of oil to each spacer tube on the tension arm assembly. (Where
applicable)
7.3.5
Annually
1. Check the intermediate pulley bearings for wear.
2. Check and remove any lint accumulation from the exhaust system.
3. Grease the bearings and the shaft of the intermediate drive pulley. Use an Alemite grease
gun and Molykote BR2-S grease. (Where applicable)
To Next Page
Loading...
Need help?
General
