55
8514-311-001 REV PR
3. Immediately, press and release the UP touch pad switch on the dryer controller. The
controller display will change from “L0Ad” to “Prog”. You have now entered the
permanent programming mode. The dry time L.E.D. will remain on and the
programming L.E.D. will illuminate.
4. Press and release the SELECT/ENTER touch pad switch once. The dry cycle L.E.D.
and programming L.E.D. will remain on, the dry time L.E.D. will illuminate, and the
dryer controller will show the number “35”.
5. Press the UP touch pad switch 18 times until the display of the dryer controller shows
the number “53”.
6. Press and release the SELECT/ENTER touch pad switch of the dryer controller once.
The dry cycle L.E.D. and programming L.E.D. will remain on, the dry time L.E.D. will
switch off, the temperature L.E.D. will illuminate, and the dryer controller display will
show the number “180”.
7. Press and release the UP touch pad switch three times until the dryer controller display
shows the number “195”.
8.
Press and release the SELECT/ENTER touch pad switch of the dryer
controller. The dry time L.E.D. and the programming L.E.D. will remain on, the
temperature L.E.D. will switch off, the cool down L.E.D. will illuminate, and the
dryer controller display will show the number “5”.
9.
Press and release the DOWN touch pad switch twice until the dryer controller
display shows the number “4”.
10. Press and release the SELECT/ENTER touch pad switch of the dryer controller.
The dry time L.E.D. and the programming L.E.D. will remain on, the cool down
L.E.D. will switch off, and the dryer controller display will change to “Prog”.
11.
Press and release the STOP touch pad switch of the dryer controller. The dry
time L.E.D. will remain on, the programming L.E.D. will switch off, and the
dryer controller display will change to the word “LOAd”.
The dryer is now ready for the new modified dry cycle to start. This modified dry cycle 1
program will remain in the dryer controller memory until the default settings push button is
pressed. This default setting push button is located on the component side of the dryer
controller printed circuit board at the lower middle side.
To Next Page
Loading...
Need help?
General
