Deye SUN2000G3 User Manual

- 01 -
Important Safety Instructions
This manual contains important instructions to follow during installation and maintenance
of the Photovoltaic Grid-connected Inverter(Microinverter).To reduce the risk of
electrical shock and ensure the safe installation and operation of the Microinverter, the
following symbols appear throughout this document to indicate dangerous conditions
and important safety instructions.
Specifications subject to change without notice - please ensure you are using the latest
manual found at the manufacturer website.
Safety Instructions
DO NOT disconnect the PV module from the Microinverter without disconnecting
the AC power.
Only qualified professionals should install and/or replace the Microinverters.
Perform all electrical installations in accordance with local electrical codes.
Before installing or using the Microinverter, please read all instructions and cautionary
markings in the technical documents and on the Microinverter system and the
solar-array.
Be aware that the body of the Microinverter is the heat sink and can reach a temperature
of 80℃. To reduce risk of burns,do not touch the body of the Microinverter.
DO NOT attempt to repair the Microinverter. If it fails, contact technical support
to obtain an RMA number and start the replacement process. Damaging or opening
the Microinverter will void the warranty.
Caution!
The external protective earthing conductor is connected to the inverter protective
earthing terminal through AC connector.
When connecting, connect the AC connector first to ensure the inverter earthing
then do the DC connections.
When disconnecting, disconnect the AC by opening the branch circuit breaker first
WARNING: This indicates a situation where failure to follow instructions may cause a
serious hardware failure or personnel danger if not applied appropriately. Use extreme
caution when performing this task.
NOTE: This indicates information that is important for optimized microinverter
operation. Follow these instructions strictly.

Deye SUN2000G3 Specifications

General

Model	SUN2000G3
Category	Inverter
Max. Input Current	13 A
Number of MPPTs	2
AC Output Frequency	50/60 Hz
Cooling	Natural convection
Protection Degree	IP65
Nominal AC Output Voltage	230V
Operating Temperature Range	-25°C to 60°C
MPPT Efficiency	99.9%
Communication	Wi-Fi