- 25 -
8. programming thE spEEd controllEr
The speed controller has more adjustments for advanced drivers:
3 operating modes "forward with brake", "forward/reverse with brake" and "rock crawler
mode" (forward/reverse, without brake)
8-stage "drag brake" setting
6-stage selection of the interrupting voltage
9-stage adjustment of the start-up behaviour ("punch") from "soft" to "very aggressive"
4-stage setting of the maximum braking strength
4 reverse speeds
4-stage setting of the braking strength when the braking takes affect
3-stage neutral operation
8-stage motor timing (only with sensorless motors)
Overheating protection on/off
Motor rotation clockwise/counterclockwise
Detection of the number of cells in the LiPo battery
The programming of the speed controller is done via the set button and the display of the red
and green LEDs.
Start of the programming mode:
Switch the speed controller off.
Switch on the transmitter.
Press and hold down the set button while you switch on the speed controller.
The red LED blinks.
1�
2�
3�
4�
5�
6�
7�
8�
9�
10�
11�
12�
>
>
>
>
To Next Page
Loading...
Need help?
General