DFI CH960-CM246 - Page 35

www.dfi .com
35
Chapter 3 BIOS Setup www.dfi .comChapter 4 BIOS Setup
35
Chapter 4
Aptio Setup Utility - Copyright (C) 2019 American Megatrends, Inc.
Version 2.20.1271. Copyright (C) 2019 American Megatrends, Inc.
ME State
Manageability Features State
AMT BIOS Features

AMT Confi guration
ME Unconfi g on RTC Clear

Firmware Update Confi guration
Advanced
[Enabled]
[Enabled]
[Enabled]
[Enabled]
 Select Screen
 Select Item
Enter: Select
+/
- :
Change Opt.
F1: General Help
F2: Previous Values
F9: Optimized Defaults
F10: Save & Exit
ESC: Exit
Confi gure Intel(R) Active
Management Technology
Parameters
USB Provisioning of AMT
Enable or disable AMT USB Provisioning.
Secure Erase Configuration
This section is used to configure Secure Erase.
OEM Flags Settings
This section is used to configure OEM Flags.
Aptio Setup Utility - Copyright (C) 2019 American Megatrends, Inc.
Version 2.20.1271. Copyright (C) 2019 American Megatrends, Inc.
USB Provisioning of AMT

Secure Erase Confi guration

OEM Flags Settings
Advanced
[Disabled]
 Select Screen
 Select Item
Enter: Select
+/
- :
Change Opt.
F1: General Help
F2: Previous Values
F9: Optimized Defaults
F10: Save & Exit
ESC: Exit
Enable/Disable of AMT
USB Provisioning.
Secure Erase Mode
Select Secure Erase module behavior: Simulated or Real.
Force Secure Erase
Enable or disable Force Secure Erase on next boot.
Aptio Setup Utility - Copyright (C) 2019 American Megatrends, Inc.
Version 2.20.1271. Copyright (C) 2019 American Megatrends, Inc.
Secure Erase mode
Force Secure Erase
Advanced
[Simulated]
[Disabled]
 Select Screen
 Select Item
Enter: Select
+/
- :
Change Opt.
F1: General Help
F2: Previous Values
F9: Optimized Defaults
F10: Save & Exit
ESC: Exit
Change Secure Erase
module behavior:
Simulated: Performs SE
fl ow without erasing SSD
Real: Erase SSD.
Aptio Setup Utility - Copyright (C) 2019 American Megatrends, Inc.
Version 2.20.1271. Copyright (C) 2019 American Megatrends, Inc.
USB Provisioning of AMT

Secure Erase Confi guration

OEM Flags Settings
Advanced
[Disabled]
 Select Screen
 Select Item
Enter: Select
+/
- :
Change Opt.
F1: General Help
F2: Previous Values
F9: Optimized Defaults
F10: Save & Exit
ESC: Exit
Enable/Disable of AMT
USB Provisioning.