DFI CS630-H310 - Page 68

www.dfi .com
68
Chapter 6 Intel AMT Settings
Chapter 6
11. Select Intel(R) AMT Configuration then press Enter.
Intel(R) Management Engine BIOS Extension v12.0.0.0010/Intel(R) ME v12.0.7.1122
Copyright(C) 2003-17 Intel Corporation. All Rights Reserved
MAIN MENU
> Intel(R) ME General Settings
Intel(R) AMT <Enabled>
> Intel(R) AMT Confi guration
MEBx Exit
[] =Move Highlight [Enter] =Select Entry [Esc] =Exit
12. In the Intel(R) AMT Configuration menu, select Manageability Feature Selection
then press Enter. Select Enabled or Disabled then press Enter.
Intel(R) Management Engine BIOS Extension v12.0.0.0010/Intel(R) ME v12.0.7.1122
Copyright(C) 2003-17 Intel Corporation. All Rights Reserved
Manageability Feature Selection <Enabled>
> SOL/Storage Redirection/KVM
> User Consent
Password Policy <Anytime>
> Network Setup
Activate Network Access
Unconfi gure Network Access <Full Unprovision>
> Remote Setup And Confi guration
> Power Control
Disabled
Enabled
INTEL(R) AMT CONFIGURATION
[] =Move Highlight <Enter> =Complete Entry [Esc] =Discard Changes
13. In the Intel(R) AMT Configuration menu, select SOL/Storage Redirection/KVM
then press Enter.
Intel(R) Management Engine BIOS Extension v12.0.0.0010/Intel(R) ME v12.0.7.1122
Copyright(C) 2003-17 Intel Corporation. All Rights Reserved
Manageability Feature Selection <Enabled>
> SOL/Storage Redirection/KVM
> User Consent
Password Policy <Anytime>
> Network Setup
Activate Netwok Access
Unconfi gure Network Access <Full Unprovision>
> Remote Setup And Confi guration
> Power Control
INTEL(R) AMT CONFIGURATION
[] =Move Highlight [Enter] =Select Entry [Esc] =Exit
10. Press Esc until you return to the Main Menu. Select Intel(R) AMT then press Enter.
Select Enabled or Disabled then press Enter.
Intel(R) Management Engine BIOS Extension v12.0.0.0010/Intel(R) ME v12.0.7.1122
Copyright(C) 2003-17 Intel Corporation. All Rights Reserved
MAIN MENU
> Intel(R) ME General Settings
Intel(R) AMT
<Enabled>
> Intel(R) AMT Confi guration
MEBx Exit
[] =Move Highlight [Enter] =Select Entry [Esc] =Exit