115
3
BIOS Setup
NVRAID BIOS
The NVRAID BIOS utility is used to configure and manage RAID on
Serial ATA drives and Parallel ATA drives.
After you power up the system and all drives have been detected,
the NVRAID BIOS status message screen will appear. Press the
<F10> key to enter the utility. The utility allows you to build a RAID
system on Serial ATA drives and Parallel ATA drives.
Refer to chapter 6 for steps in configuring RAID.
Important:
Before creating RAID, make sure you have installed the Serial/
Parallel ATA drives and connected the data cables otherwise you
won’t be able to enter the RAID BIOS utility.
To Next Page
Loading...
