DFI Infinity NF series - Page 50

50
2
Hardware Installation
The system board is equipped with an onboard IEEE 1394 port at
location CN3 (IEEE 1394-1) of the system board.
It is also equipped with an IEEE 1394 connector at location J8
(1394-2) for connecting an additional 1394 device. The 1394 port
may come mounted on a card-edge bracket. Install the card-edge
bracket to an available slot at the rear of the system chassis then
insert the connector that is attached to the 1394 port cable to J8.
Make sure pin 1 of the cable connector is aligned with pin 1 of the
J8.
IEEE 1394
W
W
1394-2
1394-1
1
2
9
TPA+
TPA-
Ground
Ground
TPB- TPB+
Key
+12V (fused)
+12V (fused)
Ground