14
When you contact the after-sales service of your distributor or your store, provide
him with the complete reference of your device (commercial name, type and serial
number). This information appears on the visible descriptive plate behind the device.
6. CLEANING AND MAINTENANCE
- Disconnect the device
- Clean regularly the metallic parts after each use by using only use non-abrasive
products, warm water and wash liquid: avoid the abrasive toweling. Rinse your
device with a wet sponge and dry it with a soft cloth.
- Dry the device with a clean soft cloth.
- Never clean the device under a water jet, the infiltrations would risk to damage it in
an irreparable way.
- Never immerse the cord or the plug in the water or quite other liquid to avoid any
electric shock.
- Every week, the container for the evaporation of condensation particles must be
cleaned with a wet sponge as well. To have an access, on the back of the display
remove the rear tole by unscrewing the 2 visible screws.
CAUTION: In places with a high rate of humidity (>60%), it is obligatory to
proceed to a total defrost every week.
7. TECHNICAL SPECIFICATIONS
8. REALIZING A TOTAL DEFROSTING
Stopping the machine is mandatory once a week.
- Disconnect the device.
- Empty the window.
- Stop the showcase.
- Open the door of the window.
To Next Page
Loading...
