EasyManua.ls Logo

Diamond 800 - Page 9

Diamond 800
9 pages
Print Icon
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
16
11. GUARANTEE
Conditions of guarantee
The guarantee applicable to any device is the commercial guarantee of the
distributor or the retailer. Please contact the store where you bought your device to
know the precise conditions.
The guarantee grants no right for damages.
The dispositions which follow are not exclusive of the profit of the legal guarantee
planned by articles 1641 and following ones of the Civil code relative to the defects
and the latent defects.
Exclusion clauses of the guarantee
Bad installation and bad maintenance, in particular if they do not respect
current regulations or instructions appearing in this user guide.
Guarantee cannot apply for bad manipulations during service, inappropriate usage,
negligences, device overload and electric power supply variations, overload or
defective installation.
Damages due to impacts or bad weather are not covered by the guarantee. Final
user is responsible for the transport. If delivered by a transporter, the recipient must
issue reserves before delivery.
Guarantee ends with interventions, reparations, modifications by non-qualified
persons, or inappropriate usage.
12. MAINTENANCE GUIDE
ANOMALIE
CAUSE
REMEDE
The display does not start
Switch on position « off »
Switch on position « on»
No information on the thermostat
Check the plug
The display does not stop
No refrigerating power
Clean the condenser
The display does not
regulate
Helicoïd ventilator is blocked
Remove foreign or
Eventually replace the ventilator
The temperature rises up
Presence of ice
Make a total defrost
Presence of water droplets
on the top
Appearance of ice
Adjust the parameters of defrost
Presence humidity marks on
the display
High level of humidity in the air
It is a normal atmospheric
phenomenon.
The phenomenon will disappear
on its own.
Presence of condensation on
the display
Display in defrost phase
Normal The phenomenon will
disappear on its own.
Presence of water under the
display
Container for condensation
particles is full, total defrost too late
Empty and clean the container
and reposition the holds

Related product manuals