DA435HA: 4-12
COMPRESSOR HARNESS CHART
Effective March 15, 2005, the connectors in the harnesses used on the DA435HA were upgraded. The old and new
connectors are not interchangeable, so for replacement parts, the correct harness and/or jumper must be ordered.
Use the following chart to determine the correct harness and/or jumper.
If your DA435HA connector looks like Connector A:
and your body connector looks like this: No jumper is needed.
20050629
and your body connector looks like this: Use jumper # 77441160.
If you are not using an IMT body and your connector looks like Connector A, use jumpers 301581 and 301607.
To Next Page
Loading...