POSSIBLE FAULTS
Fault Cause Remedy
Lack of electrical energy
Check the main switch,
socket, plug and power
supply cable
The emergency stop
button is blocked
Turn the button in the
direction indicated by the
arrow
The protection grid and/or
the head are lifted
Correctly lower both the
protective grid and the
head
The main switch knob is
in position “0”
Turn the knob to position
“1”
The machine does
not start
The timer knob is in
position “0”
Set the knob between 1
and 30 minutes
The spiral turns
sporadically
The chain is loose
Tighten the chain as
described in section 7.2.2
8 INFORMATION FOR DEMOLITION AND
DISPOSAL
Demolition and disposal of the machine is the sole
responsibility of the owner, who must perform these
tasks in compliance with laws in force pertaining to
safety and environmental protection in the country
where the machine is installed.
Disassembly and disposal can also be performed by a
third party, as long as an authorized entity is used for
the recovery and demolition of the materials in
question.
INSTRUCTION: always adhere to the laws in force
pertaining to disposal of materials in the country where
To Next Page
Loading...
