SERVICE EN
DiBO 23
Service
GENERAL
All maintenance activities must happen at an disconnected machine and
hoses without pressure. Allow to cool down the cleaner before performing
maintenance activities! Checking the electric components can happen
exclusively by an expert. Exclusively accessories and replacement components
which have been approved by the manufacturer can be used. Directly after
the activities all securities- and protection parts must be assembled, before
the machine is put in functioning. “a golden rule” that contributes to a perfectly
working machine with few problems, is well the following:
A daily control and cleaning of the machine frequently do wonders!
To be able to guarantee a perfectly working system, one has first necessary a
reliable and technical well considered machine, which is then faced secondly
at regular times with a thorough maintenance. Therefore the experience and
the “know-how” of DiBO a technical good working machine is insured and
large maintenance turns can be carried out by experienced DiBO technicians
by means of appointment or maintenance contract, we can suppose in advance
that it is satisfied to these two points.
MAINTENANCE DIAGRAM
1 General
Check daily by means of the maintenance diagram the high pressure cleaner.
You find the maintenance diagram on the following pages. Every other act has
been prohibited! The user of this manual may only do the maintenance activities
described in detail further below. If this case is not, then best consult the proper
maintenance technicians.
2 Periodic maintenance
DESCRIPTION PERIOD
Check the electric cables, high & low pressure hoses,
couplings and control of the oil level.
After each use
Refreshing pump oil. First 50 hours.
Cleaning water filter.
Each 50 hours/every
month
Replacement and cleaning fuel filters.
First 50 hours, each
following 200 hours
Cleaning fuel tank.
First 50 hours, each
following 200 hours
All following refreshments of pump oil. Each 200 hours.
Extra control/replacement of joints, valves, o- rings
& descaling of components by acknowledged DiBO-
technicians!
Each 600 hoursr.
3 Control of oil level and refreshing pump oile
Check for each use of the machine, the oil with the oil level glass or with the oil
level bar. Oil must stand right with the sign of the oil level glass, if this is not, oil
tops up until the sign. If oil looks milky, consult directly the DiBO technicians. To
refresh oil, work as follows:
• Unbolt the drain plug below the pump.
• Unbolt the tap with the oil level bar.
• Catch all oil in a barge and remove oil like further described in the guide.
• Force up the drain plug there and top up the oil in the breach to the upper
part to on the mark line.
• Force up the tap with the oil level bar there.
Recommended lubricants (+- 1Ltr, depending the pump): 1.836.042
To Next Page
Loading...
