COMPONENTS EN
DiBO 17
COMPONENT REVIEW
1 ELECTRIC MOTOR
The type of fuel motor depends on the type of cleaner (see “Technical data”
on page 28 ).
2 PRESSURE GAUGE
On this manometer one can read the pressure.
3 BURNER
The type of burner depends on the type of cleaner. The ‘green burner’ is a
burner that makes a higher eciency. The burner provides hot water. The
temperature of the water is adjustable. The burner is double walled. The
outside wall is air cooled by the ventilator lateral on the burner chamber. On top
of the burner one can find the burner mouth. The water supply and outlet are
both situated at the bottom of the burner.
Lime scale deposits while working at higher temperatures
The hardness of the water is possible expressed in French degrees (°F) or
German degrees (°D). The dierence is noticeable in the following equation:
1 ° F = 0.56 ° D. For example, water having a hardness of 40 ° F has a German
hardness of 40 x 0.56 = 22.4 ° D.
See the in your area prescribed hardness of drinking water. Hard water can
cause problems by means of lime scale from 30°F or 17°D. When hardened
water is now warmed / heated / or being pumped (or when hard water comes
in contact with air), this can cause calcification. Hard water is caused mainly by
the presence of two components: calcium and magnesium. So the harder the
water, the more chances on lime scale! When cleaning with high temperatures
(or at using heated water) , you obtain thus faster calcification in case of a low
hardness! This can therefore result in loss of energy eciency, higher energy
consumption and reduced capacity of water supply (including calcium deposits
on the burner coil and other water connection parts).
We, DIBO NV, therefore recommend to decalcify the machines with a burner
preventive additionally and after use of hot water rinse adequate with cold
water (if possible) to ensure optimum performance of the machine!
Pay attention on the turning direction of the motor: if the
burner does not ignite at first start it is possible that the turning
direction has to be changed (changing the line wires). These
works should be carried out by suitable qualified personnel.
Contact your DiBO dealer in order to carry out these activities.
4 HIGH PRESSURE PUMP
The type of high pressure pump depends on the type of cleaner
(see “Technical data” on page 28 ).
5 PLUG/SOCKET
The implementation of the plug/socket is country dependent. The machine
is provided from the factory without plug. The DiBO dealer will connect the
correct plug for delivery.
To Next Page
Loading...
