OPERATOR’S MANUAL
IntelliAg PDC User 2 & 3
11001-1509A-201105
48 / SYSTEM CONFIGURATION
MATERIAL SETUP CONSTANTS-LIQUID FLOW
Material Setup for Liquid Flow control.
NOTE: Refer to Control Setup to link a
material to a channel.
Figure 36
Liquid Flow Material Setup Screen
TARGET RATE
Target Rate establishes the desired rate of application in gallons per acre
(Liters/Ha).
MAX RATE
Maximum Rate establishes the maximum application rate in gallons per
acre (Liter/Ha) that the control will allow. Target Rate cannot be
incremented to a value greater than this established maximum rate.
MIN RATE
Minimum Rate establishes the minimum application rate in gallons per acre
(Liter/Ha) that the control will allow. Target Rate cannot be decremented to
a value lower than this established minimum rate.
INC/DEC %
The Increment/Decrement Percent rate establishes the percentage of
change that will be applied each time the Increment/Decrement button is
pressed on the Main Work Screen.
IMPORTANT: The maximum or minimum rates may not be reached if
the % increase or decrease, based off the Target Rate,
exceeds the maximum or minimum rate limits set.
EXAMPLE: Maximum Rate is set for 101. Target Rate is set for 100. If the %
increase is set at 2%, the maximum rate of 101 will not be met because the
% increase of 2% would exceed the 101 maximum rate limit.
To Next Page
