OPERATOR’S MANUAL
mini GAC®
11001-1437-200701
NORMAL OPERATION / 19
AUTO RANGING
Auto Ranging is an automatic feature that occurs when grain
tests out of the calibration limits (high or low) for the current grain
selection. If a product tests out of the moisture range of the
selected product, the mini GAC will look for a higher or lower
grain calibration and give the option to choose the correct
calibration. This typically occurs with corn.
A screen will automatically display to re-test the grain at the
correct calibration values (Figure 15). The new test will be saved
to the correct grain selection eliminating the need to dump the
grain and start a new test. All proceeding products will be tested
to the last grain selection unless the product tests out of that
range.
1. Press Enter at the Auto Range display to switch to the high
or low grain selection.
2.
Press On/Off/Home button to reject the analysis
.
Figure 15
Auto Ranging
AVERAGE
Grain Test Results
The Average menu allows test results to be added, read, or
cleared from the unit. Up to 10 values can be stored for each
grain. If all memory indicators are full when adding new test
results, the test results in location 1 will be replaced with the new
test results. The factory default setting is 3 values (refer to
(Figure 16).
IMPORTANT: Changing the language will reset the
memory and all saved grain tests
results will be cleared.
Corn Hi
Corn
To Next Page
Loading...
