mini GAC®
11001-1437-200701
ACCURACY / 26
OPERATOR’S MANUAL
3. Directly pour the grain into the cell using the fill cup, not using
the loading base/slider. When using this technique, try to
pour the grain in dead center.
4. Pour the grain smoothly and complete the pour in
approximately 5 seconds.
IMPROVING GRAIN TEST RESULTS
For accurate test results, place the mini GAC on a level surface.
Use the loader/striker and take a minimum of 3 separate test
readings. Use the average of the results for greatest accuracy.
The difference between the grain temperature and analyzer should
not exceed 36 degrees F (20 degrees C).
To Next Page
Loading...
