EasyManua.ls Logo

DieHard 28.71227 - Page 18

DieHard 28.71227
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
15
PROBLEM POSSIBLE CAUSE REASON/SOLUTION
The charger is making an
audible clicking sound.
Circuit breaker is cycling.
Battery is defective.
Severely discharged
battery, but otherwise it is a
good battery.
The settings may be wrong.
Check the charger settings.
Have the battery checked.
The battery may not want
to accept a charge due to
a run-down state. Allow
charging to continue until
battery has a chance to
recover sufciently to take
a charge. If more than 20
minutes, stop charging and
have the battery checked.
Charger makes a loud buzz
or hum.
Transformer laminations
vibrate (buzz).
Shorted Diode Assembly or
Output Rectier Assembly
(hum).
No problem, this is a normal
condition.
Have charger checked by a
qualied technician.
CHECK BATTERY (red)
LED is on.
Clips are not making a good
connection to the battery.
Connections are reversed.
Battery is defective (will not
accept a charge).
Check for poor connection
to battery and frame. Make
sure connection points
are clean. Rock the clips
back and forth for a better
connection.
Unplug the charger and
reverse the clips.
Have battery checked.
CHECK BATTERY (red)
LED is blinking.
Indicates the charger is in
abort mode.
See “Aborted Charge”
in the OPERATING
INSTRUCTIONS Section.

Related product manuals