How to stop oil leaking from the hood of my Digga Drill?
If the hood of your Digga Drill is leaking oil, the issue might be with the hoses or fittings. Try tightening them. If tightening doesn't solve the leak, consider replacing the leaking hose(s) or fitting(s).
What to do if Digga PDD 2 Speed is only operating in low speed?
If your Digga DC Drives are only operating in low speed, here are some things to check: 1. Power to the controller: Ensure the correct voltage (12V or 24V, depending on your setup) is supplied to the controller. A LED light should illuminate. 2. Power to the Planetary Drive: Check the LED inside the Hirschmann plug on the valve block (inside the hood). If it's not illuminated when power is applied, check the harness for power. (This clear Hirschmann plug with Power LED is a new addition, from April 2022.) 3. Controller connection: Make sure the controller is properly connected to the extension harness. 4. Extension harness connection: Verify the extension harness is securely plugged into the motor harness. 5. Voltage compatibility: If your excavator is 24V and the drive unit is set u...
To Next Page
General