Digi-Pas
®
© 2021 Digipas Technologies Inc. All Rights Reserved.
www.digipas.com
DWL-3000XY & DWL-3500XY Instruction Manual
8
Figure 8. Absolute level setting position 1 display
2. Turn the device 180° and press MODE button again to start the measurement.
Figure 9. Absolute level setting position 2 display
3. Turn the device 180° and press MODE button again to start the measurement.
Figure 10. Absolute level display
2.5. Alternate Zero Mode
Place the digital level on the surface to be measured. Press “MODE” button to set the
angle to 0° as a reference.
Please ensure the contact surfaces of the device and measuring plane are clean and free from dust
particles.
To Next Page
Loading...
Need help?
General
