Digi Connect SP User Manual

Digi Connect and ConnectPort TS Family command-line interface Administration
Digi Connect Family and ConnectPort TS Family
122
set user
Use the set user command to configure a user.
set wlan
Use the set wlan command to configure wireless devices.
set wlan
Use the set wlan command to configure wireless devices.
status
Use the status command to display a list of sessions or outgoing connections made by the connect,
rlogin, or telnet commands for a Digi device. Use the status command to determine which of the
current sessions to close.
show
Use the show commands to display current settings on a Digi device.
telnet
Use the telnet command to establish an outgoing telnet connection, also known as a session.
who and kill
Use the who command to display a global list of connections. The list of connections includes those
associated with a serial port or the command-line interface.
Use the kill command to terminate active connections based on the IDnumber returned from the
who results.
Use the who command to determine any connections that are no longer needed, and end the
connections by issuing a kill command.
Administration
You can issue commands from the command-line interface to administer Digi Connect and
ConnectPort TS Family products. The following table displays several administration tasks and the
commands used to perform them. See the Digi Connect® Family Command Reference for more
complete command descriptions.
Administrative task Command
Backup/restore a configuration from a
TFTP server on the network
backup

Digi Connect SP Specifications

General

Brand	Digi
Model	Connect SP
Category	Server
Language	English