Command descriptions set snmp
ConnectPort® LTS Command Reference
120
set snmp
Purpose
Configures the Simple Network Management Protocol (SNMP) agent, or displays current SNMP
settings.
Required permissions
For products with two or more users, permissions must be set to “set permissions s-snmp=read” to
display SNMP service settings, and “set permissions s-snmp=rw” to display and change SNMP service
settings. See "set permissions" for details on setting user permissions for commands.
Syntax
Set SNMP settings
set snmp[
snmpv1v2c
options]
[
snmpv3 options
]
[
snmp trap options
]
[
snmpv3 trap options
]
Where:
[
snmpv1v2c
options] are:
[snmpv1v2_enabled={off|on}]
[publiccommunity=
string
]
[privatecommunity=
string
[snmpv1v2_permission={get_only|get_set}]
[
snmpv3 options
] are:
[snmpv3 enabled={off|on}]
[security_level={auth nopriv|auth priv|
noauth_nopriv}]
[snmpv3_permission={get only|get set}]
[auth_user=
username
]
[auth_protocol={md5|sha}]
[auth_pwd=
password
]
[priv_protocol={des|aes}]
[priv_pwd=
password
]
[
snmp trap options
] are:
[trap version={none|v1|v2c|v3}]
[trap_community=
string
]
[trapdestip={
ip address
|
fqdn
}]
[trapsecdest={
ip address
|
fqdn
}]
[authfailtrap={off|on}]
[coldstarttrap={off|on}]
To Next Page
Loading...
Need help?
General