Command descriptions set pmodem
ConnectPort® LTS Command Reference
84
set pmodem
Purpose
Configures various options for modem emulation over TCP/IP, and display current modem-emulation
settings.
Required permissions
For products with two or more users, to use this command, permissions must be set to one of the
following:
n For a user to display the modem emulation settings for the line on which they are logged in:
“set permissions s-pmodem=r-self”
n For a user to display the modem emulation settings for any line: “set permissions s-
pmodem=read”
n For a user to display and set the modem emulation settings for the line on which they are
logged in: “set permissions s-pmodem=rw-self”
n For a user to display the modem emulation settings for any line, and set modem emulation
settings for the line on which the user is logged in: “set permissions s-pmodem=w-self-r”
n For a user to display and set the modem emulation settings on any line: “set permissions s-
pmodem=rw”
See "set permissions" for details on setting user permissions for commands.
Syntax
Configure modem emulation
The connection-type option, "telnet," applies to both incoming and outgoing calls via the pmodem
feature.
set pmodem port=
range
[state={on|off}]
[telnet={on|off}]
Display modem-emulation settings
set pmodem [port=
range
]
Options
port=range
Used to specify the serial port.
state={on|off}
Used to enable or disable modem emulation on a given serial port.
To Next Page
Loading...
Need help?
General