Command descriptions set rtstoggle
ConnectPort® LTS Command Reference
103
on
Enables the RTS toggle feature.
off
Disables the RTS toggle feature.
The default is “off”.
predelay=delay
Specifies the time in milliseconds to wait after the RTS signal is turned on before sending data. The
range is 0 to 5000 milliseconds. The default is 0.
postdelay=delay
Specifies the time in milliseconds to wait after sending data before turning off the RTS signal. The
range is 0 to 5000 milliseconds. The default is 0.
Example
#> set rtstoggle state=on predelay=10
See also
n revert
n show
To Next Page
Loading...
