Digi ConnectPort LTS8 - Page 164

Command descriptions show
ConnectPort® LTS Command Reference
164
range=range
A configuration table entry or range of entries.
Examples
Display network configuration settings
#> show network
Network configuration
"eth0" interface configuration
MAC address : 00:04:9F:EF:23:33
IPv6 Link addr : fe80::204:9fff:feef:2333/64
IPv6 Site addr :
IPv6 Global addr : (Currently in use)
Currently in use by
the network stack Stored configuration
----------------------- -----------------------
IPv4 options
mode_v4 : static static
ip_v4 : 192.168.4.47 192.168.4.47
submask_v4 : 255.255.0.0 255.255.0.0
gateway_v4 : 192.168.1.1 192.168.1.1
IPv6 options
mode_v6 : none none
ip_v6 : <none> (Stored configuration)
gateway_v6 : <none> (Stored configuration)
ip_6to4tunnel : off off
ip_v4_6to4relay : 192.88.99.1 192.88.99.1
ip_v6_v4addr : <none> <none>
"eth1" interface configuration
MAC address : 00:E0:0C:00:7E:21
IPv6 Link addr :
IPv6 Site addr :
IPv6 Global addr : (Currently in use)
Currently in use by
the network stack Stored configuration
----------------------- -----------------------
IPv4 options
mode_v4 : none none
ip_v4 : <none>
submask_v4 : <none>
gateway_v4 : <none>
IPv6 options
mode_v6 : none none