Command descriptions set buffer
ConnectPort® LTS Command Reference
57
The port or ports to which the command applies. To configure settings for the XBee port, specify
port=xbee. And to configure settings for an internal modem port, specify “port=internalmodem.”
size
The size in kilobytes to configure the buffer. Settings are configurable in 2-kilobyte increments. The
maximum size is 64 kilobytes. The default is 32 kilobytes.
state
The buffering state, which can be any of the following:
on
The data will be buffered.
off
The data will not be buffered and all data will be cleared from the buffer.
pause
The data will not be buffered, but data in the buffer will not be cleared.
autobk
Automatic data backup option. The data will be buffered on following storage location.
none
Automatic data backup will not be enabled.
nfs
The data will be buffered on NFS server.
samba
The data will be buffered on Samba server.
sdmemory
The data will be buffered on SD memory.
usb
The data will be buffered on USB storage device.
autobk_size
The buffer size for automatic data backup option.
syslog_state
The data will be sent to SYSLOG server. To configure SYSLOG server, see “set syslog” command.
on
The data will be sent to SYSLOG server.
off
The data will not be send to SYSLOG server.
Examples
Display port buffer configuration for all ports
To Next Page
Loading...
Need help?
General