Digi DC-190 - Page 29

5.2.4. Set Point Upper and Limit of
Set Point 1 : Weight (See Note Below) 1 ;
Set 2 : Weight (See Note Below) 2: TARE
Set bit 0 and 1 of Spec 7 to 3: GROSS
4: INSUFFICIENT
5: RECOMPUTATION
6: MEMORY
7: PROG
8: KG
9: LB
BATTERY LOW
11: 1
12: SCALE 2
13: SCALE 3
14: SCALE 4
15: IN
16: OUT
S/No.
OPERATION
DISPLAY
INDICATORS
REMARKS
WEIGHT UNIT
WEIGHT
QUANTITY 1 2 3
4 5 G 7
8
9 1
0
1
1
1 1
3
1
4
1
5
1
1
0.0000
0
0
• •
*
Display in the weighing mode
2
[MODE]
ProG
C 0
•
•
Press the [MODE] key to go into the
mode.
3
0.
• •
Press key to go into Set Point
Programming Mode.
4
raiJ[0][0][0][0]
SEt 1
3.0000
Enter the upper weight value for Set
1 using the keys
depending on the capacity the
scale. Please see the note
5
2
0.
•
•
Press the key to program Set
Point 2.
6
2
2.0000
• •
Enter the lower weight value for Set
Point 2 using [Numeric] keys.
Please see the note below.
7
ProG
C 0
•
Pressing the key exits from the
Set Point Programming mode, but
remains in the Programming mode.
8
[MODE]
0.0000
0
0
• • •
*
Pressing the [MODE] exits from
Programming mode and returns to
Note : Set Point 1 : Must be a value depending on the capacity of the scale-
Set Point 2 : Weight value up to the capacity of the scale, but Set Point 2 value must be less than Set Point 1 value.
DC-190 OPERATION
All manuals and user guides at all-guides.com