- UP THREE CHANNEL SCALE
Normaltv
Set
0001
SCALE
00: Internal Scale 1
Internal Scale 2
10: External Scale
11: Force Balance
SCALE 2:
00: Internal Scale 1
01:
2
10: External Scale
11: Force Balance
Normaltv
Set
SCALE 3:
00:
1
01: Internal Scale 2
10: External Scale
11: Force Balance
SCALE 4:
00: Internal Scale 1
01: Internal Scale 2
10: External Scale
11: Force
Load Cells
2 Would Be Plugged Into The
Load Cell Connector,
A
Cable. The Other Load
Cell Would Be Plugged Into The Remote Platform Connector. (See pg.
for remote platform connector)
If You Are Using The
Platform As Scale 1 No Power Supply
Be
As Power Will Be Supplied By
That
If
Are Using Any Other Type Of Platform It Will Be Necessary To Use A
Power Supply
In This Case Other Specs That
Need To Be Set Are As Follows :
and Measures Specification: To enter this
enter the
keys
while pressing the
zero Key. The Span Switch must be
to enter
mode.
Spec No.
3 |
2
|
20 Minimum Display
Scale
00 : 2 10 : 5
01
11
Display (Scale 2)
00 : 2 10 : 5
01
21 Decimal Point Position
1)
000 : 00000 010 : 000.00 100 : 0.0000
011
22 Weight Decimal Point Position (Scale 2)
001
011
23
Set
0 0 1 1
Display
01
11 : Not Used
Zero Setting Range
FS
01
11
Not Avail.
25
00 1 0
Scale Starting Method
0 : Automatic
1 : Manual
Mode
protected by
Span Switch
0 : No
1 :
Yes
Scale Type
1 : Double
Scale
Gross Mode
Available
0 : Yes
1 :No
32
1 0 1 0
Mode
protected by
0 : Yes 1 : No
Battery Low
Lamp
0: Yes
Auto Exit from
Add Mode
0 : No 1 : Yes
External Load Cell
3)
1 : Yes
33
0
Mask at
1
Weight Decimal Point Position (Scale 3}
010
001
36
00
Minimum Display
Scale 3)
00:2
Board
3)
00 : Normal
01 : Prevent from Small vibration
fast change In
10 : Prevent from Medium vibration
: Prevent from
slow
To Select The Minimum Display And Decimal Location Divide Capacity
The
Resolution Selected
Spec23.
In This Case Scale
3
Be Turned On.
62
IF YOU ARE SETTING UP A THREE CHANNEL SCALE WITH THREE PLATFORMS USING A
CABLE THIS
THE WAY THE SPECS 16
17 SHOULD BE SET.
To Next Page
Loading...
