tA,
SO OAK STREET Tele: 201-784-3400
NORWOOD NJ 07648
OPERATION
QUICK GUIDE
Sample & Count
Sampling Procedure (To develop the Unit
with Negative
Press [REZERO] & [TARE] keys to set up the
2. Press [CLEAR] key to clear unit weight
Place full container onto scale platform; press
(The weight display will zero)
4. Remove 10 piece sample from container; press
The unit weight will be
shown in the unit
weight window.
5. For increased sampling
you can
unit weight by
removing
pieces (about
at a time)
from the
the indicator is
then pressing
[PIECES] key will recalculate the unit weight It is not
to
hand count the additional pieces.
may
again and
again if the parts are not very uniform;
Place the sample pieces back into the container.
Counting Procedure
To count the in parts
container)
7. Key
the known tare weight. Press the [TARE] key.
The net weight of the container will be displayed, and the total
Quantity
the
will be shown in the quantity window.
•DIG!
That Counts
To Next Page
Loading...
