Calibration 21
full capacity of the scale (i.e. a 10 lb weight for 10 lb capacity scale, etc.) If the reference weight is not
equal to the full capacity of the scale, it must at least be greater than 10% of the full scale capacity.
Enter the value of the weight placed on the platter using the numeric keys before pressing the # [CODE]
key. The weight you enter will appear at the bottom of the display. Press the # [CODE] key.
8. The display will flash briefly again as the span settings for calibration of the scale are being saved, then
the display will return to Mode Menu.
9. Press 1 exit the Mode Menu and return to the Counting Mode.
To Next Page
Loading...
