SM 5100 INITIAL SETUP
2.4 DEFAULT SPECIFICATION SETTING
Default SPEC setting of individual country.
(Please turn on the span switch before proceed this process.)
¾ Country Set
DISPLAY
OPERATION
TARE lb
＄/lb
TARE
REMARK
lb
Z1.0 RESET SALES DAILY Z mode.Lamp Z turns on.
[Rezero]+[8][8][2][2] SPEC 2-STD COUNTRY Set country setting.
[>>] SPEC 1-U1 COUNTRY
[>>],[<<] or [X] to select country.[*]
to update country setting.
[*] LOAD DEFAULT SPEC Y-C N-T
[C] to load default SPEC
setting,[T] to skip.
[C] SCALE TYPE → POLE Set scale type.
[X] … [X] SCALE TYPE → BENCH
[X],[－] to select type [11] or [12]
5100B or 5100P ,[*] to update type
setting.
[*] SCALE CAP. → 3KG Set scale capacity.
[X] SCALE CAP. → 15lb
[X],[ － ] to select capacity,[*] to
update capacity setting.
[*] SCALE RES. → 1/3000S Set resolution.
[X] SCALE RES. → 1/3000M
[X],[－] to select resolution,[*] to
update resolution setting.
[*] CLEAR MEMORY Y-C N-T [C] to clear memory,[T] to skip.
[C] Z1.0 RESET SALES DAILY Return to Z mode.
Note 1:
For the first using of SM-5100, please take this operation for initialization.
Note 2: Enter a number that represent a country in the country list (refer to the table below)
to initialise and country set.
13
To Next Page
Loading...
