Digi SM-5100 Service Manual

SM 5100 SOFTWARE SETTING
SPEC
017
(000~441 is enabled)
[>>]
SPEC
017
XXX XXX
[>>] key select SPEC data.
Move cursor right.
[<<]
SPEC
017
XXX XXX
[<<] key select SPEC data.
Move cursor left.
[1]
[*]
SPEC
017
SPEC
018
001
XXX
XXX
XXX
[C]
SPEC
018
000 XXX
Clear the enter data.
[PLU]
* Note 1
Z1.0 RESET SALES DAILY
Store the updated specification
and escape to Z mode.
* Remark: The Weight in the display window will display the SPEC number. The Unit
Price window will display the new value setting entered. The Total Price
window will display the old value setting. The selection you have made will
be highlighted in the dot matrix display. Please use [︾] to increase spec
count, [︽] to decrease spec count, [*] to store a new value and [PLU] to save
spec setting.
4.2.2 Weight & Measurement SPEC Setting
To change the setting of the Weight & Measurement SPEC if there are some SPEC need to alter.
(Please turn on the span switch when using this process)
DISPLAY
OPERATION
TARE lb
＄/lb ＄
REMARK
Press SPAN
SWITCH
Z1.0 RESET SALES DAILY SPAN SWITCH is on(ENABLE).
[Rezero]+[1][4][2]
SPEC
600
XXX
(setting)
XXX
(former)
Enter [1][4][2] while depressing
[Rezero].
XXX:SPEC data
[︾]
SPEC
601
XXX XXX
[︾]key only increase specification
count, it does not update SPEC
data.
[︽]
SPEC
600
XXX XXX
[ ︽ ]key only decrease
specification count, it does not
update SPEC data.
[6][1][5] SPEC 615 XXX It goes to a designed specification
29
All manuals and user guides at all-guides.com

Digi SM-5100 Specifications

General

Brand	Digi
Model	SM-5100
Category	Printer
Language	English