Digi SM-5300 - Page 105

Preset Key Assignment
–––––––––––––––––––––––––––––––––––––
3.4 Programming of Preset Keys
M o d e l S M - 5 3 00 O p e r a t i o n M a n u a l | 104
3.4.4 Change Mode key Programming
There are 17 pages of preset keys in Change Mode Keys Programming Mode. In this mode
allow assigning maximum of 200 preset keys for all the PLU and other Functions Keys,
(refer to 3. 2.4 Change Mode Key Layout).
Note: Non-existing PLU and Function Numbers cannot be assigned.
3.4.4.1 Flex_Func and other Function Assignment
OPERATION
DISPLAY
1.
In Preset Key Programming, Enter group
number (e.g. 0)
Note: adjust Primary keys, Secondary keys and
Accumulation keys to desired display size
2.
Touch [CHANGE MODE] key.
3.
Method 1: Assign by entering the existing
Flex_Function Number by using the keypad.
Enter the Flex_Function Number by the
keypad.
(e.g. 98 for CHANGE)
Touch the desired preset key.
Note: [DATA TYPE] key only show
FLEX_FUNC and COLOR.