Digi SM-5300 - Page 66

Preset Key Assignment
–––––––––––––––––––––––––––––––––––––
3.4 Programming of Preset Keys
M o d e l S M - 5 3 00 O p e r a t i o n M a n u a l | 65
OPERATION
DISPLAY
4.
Method 1: Assign by entering the existing
Clerk Number by using the keypad.
Enter the Clerk Number by the keypad.
(e.g. 1)
Touch the desired preset key.
(e.g. Row #4, Column #1)
5.
Method 2: Assign by browsing the existing
Clerk Data.
Touch [CLERK] area to browse the existing
Clerk Data.
Note: Touch or key for more selection
6.
Touch the desired Clerk key. (e. g. Clerk 2).
Or entry Clerk number by keypad then touch
[ENTER] key
Touch the desired preset key.
(e.g. Row #3, Column #4)
7.
Press [X] key at keypad to exit to keys
selection mode.
Note: Touch [MENU] key to exit to the
Programming Mode.