Digi SM-5300 - USB Data Backup and Restore

Preset Key Assignment
–––––––––––––––––––––––––––––––––––––
3.4 Programming of Preset Keys
M o d e l S M - 5 3 00 O p e r a t i o n M a n u a l | 84
3.4.2 Secondary Key Programming
There are 10 pages of preset keys in Secondary Keys Programming Mode. In this mode
allow assigning maximum of 10 preset keys for the entire PLU and other Functions Keys
(refer to Secondary Key Layout). Usually in Secondary Keys, Function and other Functions
Keys is being assigned. In Registration Mode, Secondary Key can be select by using the
FUNCTION key on top of the numeric keys. There are two methods to assign PLU and
other Functions on preset key.
Note: 1. Non-existing PLU and Function Numbers cannot be assigned.
3.4.2.1 PLU and other Function Assignment
OPERATION
DISPLAY
1.
In Preset Key Programming, Enter group
number (e.g. 0)
Note: adjust Primary keys, Secondary keys and
Accumulation keys to desired display size
2.
Touch [SECONDARY KEYS] key.
3.
Method 1: Assign by entering the existing
PLU Number by using the keypad.
Enter the PLU Number by the keypad. (e.g.
8)
Touch the desired preset key.