© 2014 Digi International Inc. 85
XBee/XBee-PRO
®
DigiMesh 2.4 User Manual
Example. In the above example, a device with a 64-bit address of 0x0013A200 40522BAA sends
a broadcast data transmission to a remote device with payload "RxData". Suppose the
transmission was sent with source and destination endpoints of 0xE0, cluster ID=0x2211, and
profile ID=0xC105. If AO=1 on the receiving device, it would send the above frame out its UART.
Node Identification Indicator
Frame Type:0x95 frame (see ND command)
This frame is received when a module transmits a node identification message to identify itself
(when AO=0). The data portion of this frame is similar to a network discovery response frame
(see ND command).
Example. If the commissioning push button is pressed on a remote router device with 64-bit
address 0x0013a200407402ac and default NI string, the following node identification indicator
would be received: 0x7e 0025 9500 13a2 0040 7402 acff fec2 fffe 0013 a200 4074 02ac 2000
fffe 0101 c105 101e 000c 0000 2e33
Checksum 23 0xF5
0xFF - the 8 bit sum of bytes from
offset 3 to this byte.
Frame Fields Offset Example Description
To Next Page
Loading...
Need help?
General
