Digi XBee User Manual

© 2014 Digi International Inc. 93
XBee/XBee-PRO
®
DigiMesh 2.4 User Manual
Europe (ETSI)
The XBee-PRO
®
RF Module has been certified for use in several European countries. For a
complete list, refer to www.digi.com.
If the XBee-PRO
®
RF Modules are incorporated into a product, the manufacturer must ensure
compliance of the final product to the European harmonized EMC and low-voltage/safety
standards. A Declaration of Conformity must be issued for each of these standards and kept on
file as described in Annex II of the R&TTE Directive.
Furthermore, the manufacturer must maintain a copy of the XBee-PRO® user manual
documentation and ensure the final product does not exceed the specified power ratings,
antenna specifications, and/or installation requirements as specified in the user manual. If any of
these specifications are exceeded in the final product, a submission must be made to a notified
body for compliance testing to all required standards.
OEM Labeling Requirements
The 'CE' marking must be affixed to a visible location on the OEM product.
CE Labeling Requirements
The CE mark shall consist of the initials "CE" taking the following form:
• If the CE marking is reduced or enlarged, the proportions given in the above graduated
drawing must be respected.
• The CE marking must have a height of at least 5mm except where this is not possible on
account of the nature of the apparatus.
• The CE marking must be affixed visibly, legibly, and indelibly.
Restrictions
Power Output: “Power Output: The power output of the XBee-PRO RF Modules must not
exceed 10 dBm. The power level is set using the PL command. The International Variant of this
product is internally limited to 10 dBm.
France: France imposes restrictions on the 2.4 GHz band. Go to www.art-telecom.Fr or contact
Digi for more information.
Declarations of Conformity
Digi has issued Declarations of Conformity for the XBee-PRO® RF Modules concerning
emissions, EMC and safety.
Important Note
Digi does not list the entire set of standards that must be met for each country. Digi customers
assume full responsibility for learning and meeting the required guidelines for each country in
their distribution market. For more information relating to European compliance of an OEM

Digi XBee Specifications

General

Operating Frequency	2.4 GHz
RF Data Rate	250 kbps
Model	XBee S2C
Category	Control Unit
Operating Voltage	2.1 to 3.6V DC
Operating Temperature	-40 to +85 °C
Interface	UART
Dimensions	24.38 x 27.61 x 9.14 mm