Digi XBee

© 2014 Digi International Inc. 95
XBee/XBee-PRO
®
DigiMesh 2.4 User Manual
The integrator is responsible for its product to comply with IC ICES-003 & FCC Part 15, Sub. B -
Unintentional Radiators. ICES-003 is the same as FCC Part 15 Sub. B and Industry Canada
accepts FCC test report or CISPR 22 test report for compliance with ICES-003.
Japan (Telec)
In order to use the XBee-PRO in Japan, you must order the International version. The
International XBee-PRO RF Modules are limited to a transmit power output of 10 dBm.
Labeling Requirements
A clearly visible label on the outside of the final product enclosure must display the following
text:
R201WW07215214 (XBee)
R201WW08215111 (XBee-PRO)
Australia (C-Tick)
These products comply with requirements to be used in end products in Australia. All products
with EMC and radio communications must have a registered C-Tick mark. Registration to use the
compliance mark will only be accepted from Australian manufacturers or importers, or their
agent, in Australia.
Labeling Requirements
In order to have a C-Tick mark on an end product, a company must comply with (a) or (b)
below:
a. Have a company presence in Australia
2 Have a company/distributor/agent in Australia that will sponsor the importing of the end
product.
Contact Digi for questions related to locating a contact in Australia.